HVAC Repair in Hurst, TX

By the Geaux 72 Air & Heat team · Updated October 1, 2026

HVAC repair in Hurst, TX usually means a 1960s or 1970s ranch house on its third system: a capacitor or contactor in July, an old closet furnace in January, and ductwork that dates from the original build. Hurst is 35 to 40 minutes from Azle by I-820 and Airport Freeway, the farthest town on our list. Call (321) 478-0693 at any hour. The line is answered 24/7, we assign the nearest available technician, and we confirm timing before you hang up.

Most Hurst homes are about the same age, and most are on their third air conditioner. Original ducts and a 1960s furnace closet feeding equipment bought in the 2010s: that is the starting point for most calls here.

Third systems on original ducts: the Hurst ranch-house problem

Hurst went from 10,165 residents in 1960 to 27,215 in 1970, nearly tripling in ten years, and counted 40,413 at the 2020 Census. That decade produced street after street of brick ranch homes, many with a gas furnace in a hall closet and ducts in the attic. Fifty to sixty years later, the furnace and AC have been swapped two or three times. The ducts often have not.

That is where the trouble starts. Original metal ducts may be sound but leak at every seam, and flex runs added during earlier retrofits are now old themselves. Return air was sized for the first system. A new, higher-efficiency AC on that duct system can run long and still leave rooms warm, which is why air duct repair and replacement is so often part of AC installation in Hurst.

Plenty of these homes still have an R-22 system that has been nursed along. With R-22 production ended in 2020, recharging a leaking one depends on scarce reclaimed supply, and R-410A is being phased down too. Our guide to repairing or replacing an R-22 or R-410A system walks through when a repair still makes sense.

Pipeline, Precinct Line and Airport Freeway: Hurst at a glance

Original metal supply trunk and newer flex duct in the attic of a 1960s ranch home in Hurst, TX

Airport Freeway (SH 121/183) cuts across Hurst, with North East Mall, open since 1972, on one side of town and Bell's plant and training facilities along Trinity Boulevard on the other. Pipeline Road and Precinct Line Road carry most of the local traffic, and the ranch-house streets between them generate a steady share of our calls.

North Hurst around Chisholm Park and the streets near Tarrant County College's Northeast Campus share that pattern, and most of the city is in Hurst-Euless-Bedford ISD. In winter, older closet furnaces get a hard test, and a cracked heat exchanger or failing inducer motor is a furnace repair call that should not wait. In summer it is AC repair: capacitors, contactors and refrigerant leaks.

Replacements inside the city go through the City of Hurst's Building Inspections division, which issues the permits and does the inspections for work on homes in town. Hurst adopted the 2021 International Codes in October 2022, so a new system goes in under current mechanical and energy rules even when the house is 60 years old. The licensed contractor pulls the permit and schedules the inspection; a straightforward AC repair does not need one.

Example job (placeholder until a real, customer-approved story replaces it): A 1964 ranch near Chisholm Park had a 2015 AC that never quite cooled the back half of the house. The technician measured static pressure, found it well above the blower's rating, and traced it to the original undersized return and a supply trunk with open seams in the attic. Instead of a bigger system, the contractor priced a new return drop and a resealed trunk, and the existing AC began holding temperature in the back bedrooms.

HVAC services we bring to Hurst

AC Installation and Replacement in HurstAn old R-22 unit, a third big repair in two summers or a house that never cooled right. The contractor we send sizes the new system with a load calculation, matches the condenser, coil and furnace or air handler, pulls the permit and tests the start-up. You get a written quote first.Furnace and Heating Repair in HurstNo heat, cold air from the vents or a furnace that lights and quits. Gas furnaces on Atmos lines, propane furnaces on rural properties and electric heat strips in all-electric homes each fail differently. The technician we send finds the fault, checks for carbon monoxide risks and prices the repair before work.Air Duct Repair and Replacement in HurstHot back bedrooms, weak airflow or a dusty house often trace to the ducts, not the AC. We dispatch licensed HVAC contractors to test duct leakage and static pressure, repair sagging or crushed attic flex duct, add return air, fix manufactured-home crossovers and replace worn duct systems around Azle.AC Repair in HurstWarm air from the vents, a condenser that hums but will not start, ice on the copper lines or water dripping from the attic. The technician we send finds the failed part, gives you a written price before any repair, then tests the system under load. Capacitors, contactors, fan motors, leaks and drains.

Also available in Hurst: heat pump repair and installation and 24/7 emergency AC and heating repair.

Why Hurst residents call Geaux 72 Air & Heat

Original-duct know-how

Ducts here are often older than the equipment, so the technician tests them before suggesting a bigger unit.

R-22 straight talk

If your system still runs R-22, the contractor explains repair versus replacement in plain terms, with prices before work starts.

Upfront about the drive

Hurst is 35 to 40 minutes from Azle, the far edge of our area. We confirm timing on the call, based on the nearest available technician.

Licensed and answered 24/7

Every HVAC contractor we send is licensed and insured in Texas. Call (321) 478-0693 day or night.

Hurst on our service map

Serving Azle, TX 76020 and nearby areasGet directions

HVAC questions from Hurst

My 1960s Hurst home has its original ductwork. Does it need replacing with a new AC?

Not always, but it needs testing before the new system goes in. Old metal ducts can still be serviceable once the seams are sealed, while old flex runs, crushed boots and undersized returns usually need replacing. The contractor checks static pressure and, where useful, duct leakage, then tells you which parts can stay. Skipping that step is how a new, efficient AC ends up running long and cooling poorly in an older Hurst ranch home.

How fast can a technician reach Hurst?

Typical drive time from Azle to Hurst is 35 to 40 minutes by I-820 and Airport Freeway, longer at rush hour. Hurst is at the outer edge of our service area, so the actual arrival depends on where the nearest available technician is when you call, and we confirm timing on the phone rather than promise it. The line at (321) 478-0693 is answered 24/7.

Is an old closet furnace safe to keep running?

It can be, if it is inspected. Age alone does not make a furnace unsafe, but older units are more likely to have a cracked heat exchanger, a corroded flue or poor combustion air in a tight closet, any of which can let carbon monoxide into the house. Keep a working CO alarm near the bedrooms. If it sounds or you smell gas, leave the house first, then call Atmos Energy and 911 from outside. A technician can inspect it before the season.

Is it worth repairing an R-22 air conditioner in Hurst?

For a small repair, often yes. A capacitor, contactor or fan motor has nothing to do with refrigerant and can keep an R-22 system running. A leak is different: R-22 production ended in 2020, so recharging depends on reclaimed supply that is scarce and costly, and the leak has to be found and fixed first either way. If the leak is in the coil or the compressor has failed, replacement is usually the sensible choice. The contractor prices both before any work.

Does a new AC or furnace in Hurst need a city permit?

Yes, a system replacement inside Hurst city limits needs a permit and an inspection through the City of Hurst Building Inspections division, which works from the 2021 International Codes the city adopted in 2022. The licensed contractor applies for the permit and schedules the inspection as part of the job. Ordinary repairs such as a capacitor, contactor or drain line do not need a permit.